SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS

Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for any additional exposure limit guidelines.

SECTION 3: HAZARDS IDENTIFICATION

EMERGENCY OVERVIEW

HMIS RATING: HEALTH -- 1 FLAMMABILITY -- 2 REACTIVITY -- 0
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.

POTENTIAL HEALTH EFFECTS FROM ROUTE OF ENTRY
EYE: Can cause moderate irritation, tearing and reddening, but not likely to permanently injure eye tissue.
SKIN: Can cause minor skin irritation, defatting, and dermatitis
Component(s) may be absorbed through intact skin, but is unlikely that harmful effects will occur unless contact is prolonged, repeated and extensive .
INHALATION: No irritation hazard in normal industrial use
Inhalation of high concentrations may result in ventral nervous system (CNS) effects such as dizziness, weakness, fatigue, nausea, headache, and lack of coordination .
INGESTION: Ingestion is not anticipated route of exposure. Harmful if swallowed. Irritating to mouth, throat, and stomach

LONG-TERM (CHRONIC) HEALTH EFFECTS
TARGET ORGAN(S): No organs known to be damaged from exposure to this product.

REGULATED CARCINOGEN STATUS: Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH< or OSHA listed carcinogens

EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: No medical conditions affected by exposure.

SECTION 4: FIRST AID MEASURES

IF IN EYES: Flush eyes with plenty of water for at least 20 minutes retracting eyelids often. Tilt the head to prevent chemical from transferring to uncontaminated eye. Get immediate medical attention

IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists

IF VAPORS INHALED: Remove individual to fresh air after an airborne exposure if any symptoms develop, as a
precautionary measure.

IF SWALLOWED: Do not induce vomiting. Seek medical attention immediately. Drink two glasses of water or milk to dilute. Do not give anything by mouth to an unconscious person. Induced vomiting may lead to aspiration of the material into the lungs potentially causing chemical pneumonitis that may be fatal.

SECTION 5: FIRE FIGHTING MEASURES

FLASH POINT: T.C.C. 110F

AUTOIGNITION TEMPERATURE: Not established

LOWER EXPLOSIVE LIMIT (% in air): Not established

UPPER EXPLOSIVE LIMIT (% in air): Not established

EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.

UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.

SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self contained
breathing apparatus and full protective equipment.

HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide

SECTION 6: ACCIDENTAL RELEASE MEASURES

SPECIAL PROTECTION: Clean up of spilled material may be irritating.
Follow personal protective equipment recommendations found in Section 8
of this MSDS.

CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.

Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300

SECTION 7: HANDLING AND STORAGE

Handling: Moderately irritating material. Use only in well ventilated area
Wash thoroughly after handling.
Keep container closed
Emptied container retains vapor and product residue

Storage: Store in a cool, ventilated location. Keep container closed.

Consult the Technical Data Sheet for specific storage instructions.

SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION

EYE PROTECTION: Wear safety glasses when handling this product. Have an eye wash station available.

SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves

GLOVES: Not normally required.

RESPIRATORY PROTECTION: No respirator protection required under normal conditions of use.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).

VENTILATION: Use local exhaust ventilation when practical

EXPOSURE LIMITS:

SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES

PHYSICAL STATE:                                  Liquid
COLOR:                                                White
ODOR:                                                  Alcohol
ODOR THRESHOLD:                               Not established
WEIGHT PER GALLON (lbs.):                   Approximately 8.2
SPECIFIC GRAVITY:                              Approximately 1.1
BOILING POINT (deg. C):                       Not established
FREEZING/MELTING POINT (deg. C):       Not established
VAPOR PRESSURE (mm Hg):                   Not established
VAPOR DENSITY:                                   Not established
EVAPORATION RATE:                             Not established
OCTANOL/WATER COEFFICIENT:             Not established

SECTION 10: STABILITY AND REACTIVITY

STABILITY: Stable under normal conditions.

CHEMICAL INCOMPATIBILITY: Not established

HAZARDOUS POLYMERIZATION: Will not occur.

HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide

SECTION 12: ECOLOGICAL INFORMATION

OVERVIEW: No ecological information available

SECTION 13: DISPOSAL CONSIDERATIONS

To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA
Hazardous Waste Regulations 40 CFR 261. For assistance with your maste management needs contact HAR Adhesive Technologies at 440-786-7185

SECTION 14: TRANSPORTATION INFORMATION

Consult Bill of Lading for transportation information.

DOT: NOT REGULATED.

IATA: NOT REGULATED.

SECTION 15: REGULATORY INFORMATION

INVENTORY STATUS

U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.

CANADIAN CEPA DSL: This product is in compliance with the Canadian Domestic Substance List
requirements.

EUROPEAN EINECS: This product is in compliance with European Inventory of Notified and Existing Chemical Substance requirements.

If you need more information about the inventory status of this product call 440-786-7185.

This product may contain chemical substances that are regulated for export by various government agencies (such as
the Environmental Protection Agency, the Bureau of Industry and Security, or the Drug Enforcement
Administration, among others). Before exporting this product from the USA or Canada, we recommend you contact
us at 440-786-7185.

FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 72. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.

SECTION 16: ADDITIONAL INFORMATION

This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).

Prepared by: Department of Health and Safety

Phone: 440-786-7185

The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to HAR Adhesive Technologies from its suppliers, and because HAR Adhesive Technologies has no control over the conditions of handling and use, HAR Adhesive Technologies makes no warranty,
expressed or implied, regarding the accuracy of the data or the results to be obtained from the use thereof. The
information is supplied solely for your information and consideration, and HAR Adhesive Technologies assumes no
responsibility for use or reliance thereon. It is the responsibility of the user of HAR Adhesive Technologies products to
comply with all applicable federal, state and local laws and regulations.

HAR Adhesive Technologies | 60 South Park Bedford, Ohio 44146 | Phone: 440-786-7185 | Fax: 440-786-7186 | harnetinfo@haradhesive.com

TESTIMONIALS | PRIVACY POLICY | REQUEST INFO | CONTACT | SITE MAP

©2016 - HAR Adhesive Technologies - Website Designed and Powered by INSYTE Consulting Group, LLC