CAD-COLOR 20" Magic Mask High Tack 25 Yard Roll


    95.50 95.50 95.5 USD


    This combination does not exist.

    Add to Cart

    One mask. Multiple uses.

    Masking Process for Printable Heat Transfer Material

    Step 1: Remove mask from liner.

    Step 2: Position mask over weeded design. Use a squeegee to eliminate air bubbles.

    Step 3: Remove design from carrier by pulling at a 90 degree angle.

    Step 4: Place masked design back on liner until ready to heat apply.

    Tip: Save the protective mask liner sheet to cover and protect cut design.

    Masking Process for Fabric

    Step 1: Cut fabric to fit mask.

    Step 2: Lay fabric, adhesive side up, on flat surface.

    Step 3: Remove protective sheet liner from mask. The liner is a thin sheet of plastic that covers the adhesive side of the mask.

    Step 4: Lay mask out onto fabric, adhesive side to adhesive side.

    Step 5: Feed into flatbed or vinyl cutter.

    Step 6: Set cutting specs on your cutter.

    Step 7: Cut design in "Positive Mode" - do not mirror image.

    Step 8: When ready for use, remove graphic from mask and lay out for digitizing or sewing.

    Tip: High Tack Magic Mask is reusable for approximately 10-15 uses. Simply remove unused fabric from the mask, lay down a new piece of fabric, and repeat steps 4-8.

    This is a preview of the recently viewed products by the user.
    Once the user has seen at least one product this snippet will be visible.

    Recently viewed Products